Plans for free
Plans for kids
Copyright © 2001 - 2006 www.thingstobuild.com
Single Garage Plans
3.1m (10' 2") x 6m (20ft) Shell only
Copyright © 2003 Buildeazy.Com Ltd. All rights reserved
. These and other plans in this site are the property of
. We thank Buildeazy for allowing us to host this freeplan in our site. Many other plans can be found at
Page 8: The exterior cladding (siding)
A cladding underlay should envelop the exterior walls prior to the cladding being fixed.
The cladding, 12.5 (1/2") plywood can then be fixed to the studs. All joins should be on a stud and with a gap of 3mm (1/8") between sheets.
Timber battens 75x25 (1x3) to go over each join. The battens should have a groove each side of the join to stop water being drawn up by capillary action.
Extra battens can also be fixed to intermediate studs. This is for decorative purposes only.
Click on a hyperlink below to go to that page.
Page 1: Introduction
Page 2: Identifying the parts
Page 3: Flat plan
Page 4: The wall frames
Page 5: The roof
Page 6: Detail
Page 7: The eaves
Page 8: The exterior cladding
Page 9: The roof cladding
Page 10: The angle cuts
Page 11: Bracing and fastening
Page 12: Materials list
Page 13: Cutting list
Page 14: Glossary of terms
Page 15: A guide to building the garage
<< previous page
next page >>
Copyright © 2001 - 2006 www.thingstobuild.com - All rights reserved. Reproduction of any material
in this website is strictly prohibited without expressed written permission.